How to install the automatic water level controller
1.Make one pipe which is about 1.2M( 4’1/2 ) to connect the black nuts at the bottom. At the same time the black nut and the red water level are tightened on the above screw. 2.The water pipe is fixed to the installation place, the lower end face of the water pipe position, that is, always keep the height of the water level is slightly lower 5mm position. Following a water storing device, and can also be available for trough, pigs and drinking water. 3.Connect the water supply network to the 3 '(3/8 inch) pipe thread on the back of the water level. If the water quality is poor, the filter can be installed, and the two M8# metal nut with a wrench. 4.Through the water, you can automatically water. Until the water containing device level is higher than the water level pipe is connected to the lower part of the bottom end, a water level device automatically stops the water supply; stay pig drinking water, the water surface is lower than the bottom pipe end, a water level device will automatically open the water supply to ensure that there is always water in the water containing device.
| Color | Red,Orange |
| Size | 200mm*150mm |
| Material | PA POM plastic |
| Weight | 270g |
| Design | aerodynamic principle |
| Advantage | Save water 65% |
| Application | Pig,Goat,Cattle |
| Installation | with 4" screw |
| Water pressure | 2-2.5bar(0.2mpa-0.25mpa) |
| Packing/Q'ty | 50pcs/box |
